I have a Hankook Protec-5N, of 1997 vintage, from which we have removed
the Fagor 800T system and are fitting with a Kanalog/Kflop board and
running Mach3.
The process has been made a little more difficult because we have not
been able to get accurate circuitry for the Yaskawa servopacks.
However, with Tom's help, and a lot of wire tracing, we have the saddle,
cross-slide, and spindle all working, although none of the encoders are
connected yet.
I could figure how to attach photos to this message, or even if that is
possible in Yahoo groups so I have created an album here,
http://groups.yahoo.com/group/DynoMotion/photos/album/125340567/pic/list\
, with a couple of photos to show the result of some of the work.
Ross
